Setup guide
Table Of Contents
- Front Matter
- Contents
- Introduction
- Chap 1-Setting Up Your System
- Chap 2-Running the SETUP Program
- Starting the SETUP Program
- Selecting Options
- Setting the Date and Time
- Setting the Processor Speed Options
- Setting the Fast Boot Option
- Setting the System and Video BIOS Options
- Setting the Keyboard Options
- Installed Equipment
- Setting the Built-in Paralllel and Serial Port Options
- Setting the Speaker
- Setting the Disk Drive Controllers
- Setting the Password Options
- Setting the Diskette Drive Type(s)
- Setting the Hard Disk Drive(s)
- Setting the Non-cache Areas
- Setting the Cache Test and Use Control Options
- Saving Your Settings and Exiting SETUP
- Post-SETUP Procedures
- Appendix A-Using Memory
- Index
- Diagrams
Note
Be sure to set the jumpers on any parallel or serial port
option card(s) you install to indicate how you want the
port(s) to be assigned. The SETUP options do not assign the
addresses for any port installed on an option card. See the
instructions that came with the card(s) for the correct jumper
settings.
I
Setting the Speaker
If you want the computer’s built-in speaker to beep during
certain operations you may perform, select Enabled for the
Speaker option (the default setting). If you do not want to
hear the speaker, select Disabled.
Setting the Disk Drive Controllers
If you are using the standard drive(s) that came with your
computer, you should set the Internal diskette drive
controller and Internal hard dies drive
controller options to Enabled (the defaultsettings).
However, if you install an option card to provide a controller
for a diskette drive or hard disk drive, select Disabled for the
appropriate controller option(s).
Running the SETUP Program
2-15