Setup guide
Table Of Contents
- Front Matter
- Contents
- Introduction
- Chap 1-Setting Up Your System
- Chap 2-Running the SETUP Program
- Starting the SETUP Program
- Selecting Options
- Setting the Date and Time
- Setting the Processor Speed Options
- Setting the Fast Boot Option
- Setting the System and Video BIOS Options
- Setting the Keyboard Options
- Installed Equipment
- Setting the Built-in Paralllel and Serial Port Options
- Setting the Speaker
- Setting the Disk Drive Controllers
- Setting the Password Options
- Setting the Diskette Drive Type(s)
- Setting the Hard Disk Drive(s)
- Setting the Non-cache Areas
- Setting the Cache Test and Use Control Options
- Saving Your Settings and Exiting SETUP
- Post-SETUP Procedures
- Appendix A-Using Memory
- Index
- Diagrams
Installed Equipment
SETUP displays information about the following equipment
that it detects in your system under the Installed
equipment heading:
0
Number of diskette drives
Cl
Video type
0
Math coprocessor (built-in).
You cannot change the settings for these parameters.
The Number of diskette drives installed can be 1 or 2.
You can set the type(s) of diskette drive(s) you have installed
under the Diskette Drives heading. See page 2-20 for more
information.
The video type can be one of the following:
0
EGA or VGA
0
40 Column Color
0
80 Column Color
0
Monochrome.
If you are using the built-in VGA port, or if you install an EGA
or VGA card, SETUP displays
EGA
or VGA the video type.
If you install a CGA card, SETUP displays either 40 Column
Color or 80 Column Color. SETUP displays Monochrome
if you install a monochrome display adapter card.
You see Yes at the Math
coprocessor option if SETUP
detects a built-in math coprocesso
r or No if it does not detect
one.
2-12 Running the SETUP Program