Setup guide
Table Of Contents
- Front Matter
- Contents
- Introduction
- Chap 1-Setting Up Your System
- Chap 2-Running the SETUP Program
- Starting the SETUP Program
- Selecting Options
- Setting the Date and Time
- Setting the Processor Speed Options
- Setting the Fast Boot Option
- Setting the System and Video BIOS Options
- Setting the Keyboard Options
- Installed Equipment
- Setting the Built-in Paralllel and Serial Port Options
- Setting the Speaker
- Setting the Disk Drive Controllers
- Setting the Password Options
- Setting the Diskette Drive Type(s)
- Setting the Hard Disk Drive(s)
- Setting the Non-cache Areas
- Setting the Cache Test and Use Control Options
- Saving Your Settings and Exiting SETUP
- Post-SETUP Procedures
- Appendix A-Using Memory
- Index
- Diagrams

Setting the Keyboard Options
There are four keyboad options available:
0
Keyboard function
0
Keyboard delay
0
Keyboardspeed
0
Num Lock status after boot.
The Keyboard function option allows you to change the
Keyboard delay and keyboard speed option settings. If
Keyboard function is Enabled (the default setting), you can
change the other settings. If Keyboard function is Disabled,
the Keyboard delay and speed settings are listed as N/A and
you cannot change them. You can change the Num
Lock
status after boot setting any time.
The Keyboard delay option allows you to select a delay
period between the time you press a key and the time the
character appears on the screen. You can select a delay of 0, 250,
500, 750, or 1000 ms (milliseconds); the higher the number, the
longer the delay. The default setting is 250
ms, or
I4
second.
The Keyboard
speed option sets the rate at which a character
repeats when you hold down a key. You can select virtually
any speed between 002 and 031 kps(keys per second);the
higher the number, the faster the repeat rate. The default
setting is 020 kps.
The Num Lock status after boot option allows you to
select the initial state of the num lock function when you turn
on or reset your system. You can select
ON
or
OFF; the
default
setting is ON.
Running the SETUP Program
2-11