Setup guide
Table Of Contents
- Front Matter
- Contents
- Introduction
- Chap 1-Setting Up Your System
- Chap 2-Running the SETUP Program
- Starting the SETUP Program
- Selecting Options
- Setting the Date and Time
- Setting the Processor Speed Options
- Setting the Fast Boot Option
- Setting the System and Video BIOS Options
- Setting the Keyboard Options
- Installed Equipment
- Setting the Built-in Paralllel and Serial Port Options
- Setting the Speaker
- Setting the Disk Drive Controllers
- Setting the Password Options
- Setting the Diskette Drive Type(s)
- Setting the Hard Disk Drive(s)
- Setting the Non-cache Areas
- Setting the Cache Test and Use Control Options
- Saving Your Settings and Exiting SETUP
- Post-SETUP Procedures
- Appendix A-Using Memory
- Index
- Diagrams
The
Shadow
RAM
areas option allows you to enable or
disable shadow RAM in the address ranges listed below. The
default setting for each area is listed in parentheses. If you want
to select one of these address ranges, press
[bdl
to display the
Shadow RAM areas at the end of the SETUP menu.
0
C0000h - C3FFFh (Enabled)
0
C4000h - C7FFFh (Enabled)
P
C8000h-CBFFFh (Enabled)
0
CC000h -CFFFFh (Enabled)
P
D0000h - D3FFFh (Disabled)
P
D4000h - D7FFFh (Disabled)
0
D8000h - DBFFFh (Disabled)
P
DC000h - DFFFFh (Disabled)
P
E0000h-E3FFFh (Disabled)
0
E4000h-E7FFFh (Disabled)
0
E8000h-EBFFFh (Disabled)
P
EC000h - EFFFFh (Disabled).
To enable or disable shadow RAM at an address, select the area
and press + or - to change the setting.
Note
Your computer automatically enables shadow RAM in the
address area F0000h through FFFWh. You cannot disable
shadow RAM in this area.
2-10
Running the SETUP Program