Setup guide
Table Of Contents
- Front Matter
- Contents
- Introduction
- Chap 1-Setting Up Your System
- Chap 2-Running the SETUP Program
- Starting the SETUP Program
- Selecting Options
- Setting the Date and Time
- Setting the Processor Speed Options
- Setting the Fast Boot Option
- Setting the System and Video BIOS Options
- Setting the Keyboard Options
- Installed Equipment
- Setting the Built-in Paralllel and Serial Port Options
- Setting the Speaker
- Setting the Disk Drive Controllers
- Setting the Password Options
- Setting the Diskette Drive Type(s)
- Setting the Hard Disk Drive(s)
- Setting the Non-cache Areas
- Setting the Cache Test and Use Control Options
- Saving Your Settings and Exiting SETUP
- Post-SETUP Procedures
- Appendix A-Using Memory
- Index
- Diagrams
You can change most of the SETUP options listed in this
chapter; however, the program automatically sets the following
options and you cannot change them:
0
Basememory
0
Extendedmemory
0
Number of diskette drives
0
Video type.
Selecting Options
A solid cursor bar highlights the option
currently
selected. You
canscroll through the options using
[and
t
b
When
go to the next option.
Note
If you use the + key on the main keyboard (not the
numeric keypad), be sure to hold down the
m
key.
To use the cursor control keys on the numeric keypad, press
[~)toturnoff~numlockfunction,ifnecessarv.~e
lightonthekqrisonwhenttrefunctionisenabled.)
2-4
Running
the
SETUP Program