Setup guide
Table Of Contents
- Front Matter
- Contents
- Introduction
- Chap 1-Setting Up Your System
- Chap 2-Running the SETUP Program
- Starting the SETUP Program
- Selecting Options
- Setting the Date and Time
- Setting the Processor Speed Options
- Setting the Fast Boot Option
- Setting the System and Video BIOS Options
- Setting the Keyboard Options
- Installed Equipment
- Setting the Built-in Paralllel and Serial Port Options
- Setting the Speaker
- Setting the Disk Drive Controllers
- Setting the Password Options
- Setting the Diskette Drive Type(s)
- Setting the Hard Disk Drive(s)
- Setting the Non-cache Areas
- Setting the Cache Test and Use Control Options
- Saving Your Settings and Exiting SETUP
- Post-SETUP Procedures
- Appendix A-Using Memory
- Index
- Diagrams
8
Turning On the Computer
After you set up your system, you’re ready to turn on the
power. Follow these steps:
1.
2.
3.
Turn your computer around so the front panel faces you and
place your other system devices (monitor, printer, etc.) in a
convenient arrangement.
Turn on the monitor, printer, and any other devices connected
to the computer.
To turn on the computer, press
the power button located on
the right side of the front panel.
power
(SPEED) lndicator
power
button
The power indicator on the left side of the front panel lights
up. After a few seconds, the screen displays a count of the
system memory, and then the computer performs its
power-on diagnostics. This is a series of checks the
computer runs each time you turn it on to make sure
everything is working correctly.
1-16
Setting Up Your System