Setup guide
Table Of Contents
- Front Matter
- Contents
- Introduction
- Chap 1-Setting Up Your System
- Chap 2-Running the SETUP Program
- Starting the SETUP Program
- Selecting Options
- Setting the Date and Time
- Setting the Processor Speed Options
- Setting the Fast Boot Option
- Setting the System and Video BIOS Options
- Setting the Keyboard Options
- Installed Equipment
- Setting the Built-in Paralllel and Serial Port Options
- Setting the Speaker
- Setting the Disk Drive Controllers
- Setting the Password Options
- Setting the Diskette Drive Type(s)
- Setting the Hard Disk Drive(s)
- Setting the Non-cache Areas
- Setting the Cache Test and Use Control Options
- Saving Your Settings and Exiting SETUP
- Post-SETUP Procedures
- Appendix A-Using Memory
- Index
- Diagrams
7 Connecting the Power Cord
Follow these steps to connect the power cord:
1. Plug the power cord into the AC power INLET on the back
panel, as shown below.
WARNING
To avoid an electric shock, be sure to plug the cord into
the computer before plugging it into the wall outlet
INLET
2.
Plug the other end of the power cord into an appropriate
grounded (earthed) electrical outlet.
Setting up Your system
1-15