Setup guide
Table Of Contents
- Front Matter
- Contents
- Introduction
- Chap 1-Setting Up Your System
- Chap 2-Running the SETUP Program
- Starting the SETUP Program
- Selecting Options
- Setting the Date and Time
- Setting the Processor Speed Options
- Setting the Fast Boot Option
- Setting the System and Video BIOS Options
- Setting the Keyboard Options
- Installed Equipment
- Setting the Built-in Paralllel and Serial Port Options
- Setting the Speaker
- Setting the Disk Drive Controllers
- Setting the Password Options
- Setting the Diskette Drive Type(s)
- Setting the Hard Disk Drive(s)
- Setting the Non-cache Areas
- Setting the Cache Test and Use Control Options
- Saving Your Settings and Exiting SETUP
- Post-SETUP Procedures
- Appendix A-Using Memory
- Index
- Diagrams
To connect a mouse to the built-in mouse port, plug the
connector into the port marked
MOUSE,
as shown below.
Caution
Although the connectors and ports for the mouse and
keyboard are physically identical, they cannot be used
interchangeably. Be sure to plug the mouse connector into
the MOUSE port.
If your system has not already been configured, you may need
to install a mouse driver. See your mouse manual for
instructions.
1-14
setting Up Your System