Setup guide
Table Of Contents
- Front Matter
- Contents
- Introduction
- Chap 1-Setting Up Your System
- Chap 2-Running the SETUP Program
- Starting the SETUP Program
- Selecting Options
- Setting the Date and Time
- Setting the Processor Speed Options
- Setting the Fast Boot Option
- Setting the System and Video BIOS Options
- Setting the Keyboard Options
- Installed Equipment
- Setting the Built-in Paralllel and Serial Port Options
- Setting the Speaker
- Setting the Disk Drive Controllers
- Setting the Password Options
- Setting the Diskette Drive Type(s)
- Setting the Hard Disk Drive(s)
- Setting the Non-cache Areas
- Setting the Cache Test and Use Control Options
- Saving Your Settings and Exiting SETUP
- Post-SETUP Procedures
- Appendix A-Using Memory
- Index
- Diagrams
Using the Serial Ports
If you have a printer, a modem, or other peripheral device with
a serial interface, you can connect it to one of the serial
(RS-232C) ports on the back of the computer. These ports use a
DB-9P connector, so be sure you have a compatible cable.
To connect a serial device, insert the connector into one of the
pork, marked SERIAL 1 and
SERIAL
2
If
you
are
connecting
only
one serial device, use the
SERIAL
1 port,
as
shown below.
setting up Your system
1-11