Setup guide
Table Of Contents
- Front Matter
- Contents
- Introduction
- Chap 1-Setting Up Your System
- Chap 2-Running the SETUP Program
- Starting the SETUP Program
- Selecting Options
- Setting the Date and Time
- Setting the Processor Speed Options
- Setting the Fast Boot Option
- Setting the System and Video BIOS Options
- Setting the Keyboard Options
- Installed Equipment
- Setting the Built-in Paralllel and Serial Port Options
- Setting the Speaker
- Setting the Disk Drive Controllers
- Setting the Password Options
- Setting the Diskette Drive Type(s)
- Setting the Hard Disk Drive(s)
- Setting the Non-cache Areas
- Setting the Cache Test and Use Control Options
- Saving Your Settings and Exiting SETUP
- Post-SETUP Procedures
- Appendix A-Using Memory
- Index
- Diagrams
After you install the card, connect your monitor to the
computer. If your monitor came with its own manual, follow
the instructions there. Otherwise, you can follow the steps in
“Using the VGA Port” on page 1-4; just insert your monitor
connector into the adapter card port instead of the built-in VGA
port.
4
Connecting a Printer or Other Device
Your computer has one parallel and two serial ports. To
connect a printer or other peripheral device, follow the
instructions below.
1-8
Setting Up Your system