User`s guide
Table Of Contents
- FRONT MATTER
- CONTENTS
- INTRODUCTION
- CHAP 1-USING YOUR CHAPTER
- Turning On the Computer
- Turning Off the Computer
- Using Disks and Disk Drives
- Special Keys on the Keyboard
- Stopping a Command or Program
- Resetting the Computer
- Using a Password
- Using Your Computer a Network Server
- Changing the Processor Speed
- Preparing the Hard Disk for Moving
- Using AUTOEXEC. BAT and Other Batch Files
- CHAP 2-INSTALLING AND REMOVING OPTIONS
- How to Use This Chapter
- Removing the Cover
- Changing the Jumper Settings
- Memory Modules (SIMMs)
- Installing an Option
- Removing an Option Card
- Removing the Option Card Connector Board
- Replacing the Option Card Connector Board
- Installing a New Processor Chip
- Using the Alternate VGA
- Replacing the Cover
- Post-installation Procedures
- CHAP 3-INSTALLING AND REMOVING DRIVES
- CHAP 4-RUNNING SYSTEM DIAGNOSTICS
- CHAP 5-FORMATTING A HARD DISK
- CHAP 6-TROUBLESHOOTING
- APPENDIX A-SPECIFICATIONS
- GLOSSARY
- INDEX
2.
Remove the retaining screw securing the hard disk drive and
mounting plate to the horizontal drive bays. Then slide the
hard disk drive and mounting plate in the direction of the
arrow, shown below, and lift them out of the computer.
3.
Remove the four screws securing the mounting plate to the
hard disk drive. You can store the mounting plate and its
screw or replace it in the computer and secure it with the
screw.
4.
Wrap the hard disk drive in its original packing materials
and store it along with the four screws.
5.
If you removed your computer’s only hard disk drive,
disconnect the hard disk drive ribbon cable from the main
system board and store it as well.
3-16
Installing and Removing Drives