User`s guide
Table Of Contents
- FRONT MATTER
- CONTENTS
- INTRODUCTION
- CHAP 1-USING YOUR CHAPTER
- Turning On the Computer
- Turning Off the Computer
- Using Disks and Disk Drives
- Special Keys on the Keyboard
- Stopping a Command or Program
- Resetting the Computer
- Using a Password
- Using Your Computer a Network Server
- Changing the Processor Speed
- Preparing the Hard Disk for Moving
- Using AUTOEXEC. BAT and Other Batch Files
- CHAP 2-INSTALLING AND REMOVING OPTIONS
- How to Use This Chapter
- Removing the Cover
- Changing the Jumper Settings
- Memory Modules (SIMMs)
- Installing an Option
- Removing an Option Card
- Removing the Option Card Connector Board
- Replacing the Option Card Connector Board
- Installing a New Processor Chip
- Using the Alternate VGA
- Replacing the Cover
- Post-installation Procedures
- CHAP 3-INSTALLING AND REMOVING DRIVES
- CHAP 4-RUNNING SYSTEM DIAGNOSTICS
- CHAP 5-FORMATTING A HARD DISK
- CHAP 6-TROUBLESHOOTING
- APPENDIX A-SPECIFICATIONS
- GLOSSARY
- INDEX
5.
Locate one of the power supply cables that lead from the
power supply (behind the horizontal drive bays). The
power supply cables may be secured in a plastic band on
the side of the power supply. If so, unfasten the band to free
the cables.
The cables are labelled
PA, PB, PC,
and
PD; you
can use any one
that is free. (If your drive requires a small power supply
cable connector, use
PD.)
6.
Position the power supply cable connector so that its notched
corners line up with the notched corners of the power
supply connector on the hard disk drive. Make sure the
holes fit over all the pins and then push in the connector.
Caution
If you do not align the cable connector correctly, you could
severely damage your hard disk drive when you push it in.
3-14 Installing and Removing Drives