User`s guide
Table Of Contents
- FRONT MATTER
- CONTENTS
- INTRODUCTION
- CHAP 1-USING YOUR CHAPTER
- Turning On the Computer
- Turning Off the Computer
- Using Disks and Disk Drives
- Special Keys on the Keyboard
- Stopping a Command or Program
- Resetting the Computer
- Using a Password
- Using Your Computer a Network Server
- Changing the Processor Speed
- Preparing the Hard Disk for Moving
- Using AUTOEXEC. BAT and Other Batch Files
- CHAP 2-INSTALLING AND REMOVING OPTIONS
- How to Use This Chapter
- Removing the Cover
- Changing the Jumper Settings
- Memory Modules (SIMMs)
- Installing an Option
- Removing an Option Card
- Removing the Option Card Connector Board
- Replacing the Option Card Connector Board
- Installing a New Processor Chip
- Using the Alternate VGA
- Replacing the Cover
- Post-installation Procedures
- CHAP 3-INSTALLING AND REMOVING DRIVES
- CHAP 4-RUNNING SYSTEM DIAGNOSTICS
- CHAP 5-FORMATTING A HARD DISK
- CHAP 6-TROUBLESHOOTING
- APPENDIX A-SPECIFICATIONS
- GLOSSARY
- INDEX
Connecting the Cables
To connect the hard disk drive to the computer, you need to
connect two cables: the hard disk drive ribbon cable and a
power supply cable. Follow the steps below.
1.
If you are installing your computer’s first hard disk drive,
you need to connect the hard disk drive ribbon cable to the
system board now. Follow the instructions on page 3-33
and then return here.
2.
The hard disk drive ribbon cable should be connected to the
main system board. Locate the free connector on the end of
this cable. (If there is a hard disk drive in the lower
horizontal bay, the middle connector is attached to that
drive.)
3.
Notice the small tab in the middle of the cable connector;
align this tab with the notch in the hard disk drive
connector, as shown in the following illustration.
When the hard disk drive ribbon cable is positioned
3-12 Installing and Removing Drives