User`s guide
Table Of Contents
- FRONT MATTER
- CONTENTS
- INTRODUCTION
- CHAP 1-USING YOUR CHAPTER
- Turning On the Computer
- Turning Off the Computer
- Using Disks and Disk Drives
- Special Keys on the Keyboard
- Stopping a Command or Program
- Resetting the Computer
- Using a Password
- Using Your Computer a Network Server
- Changing the Processor Speed
- Preparing the Hard Disk for Moving
- Using AUTOEXEC. BAT and Other Batch Files
- CHAP 2-INSTALLING AND REMOVING OPTIONS
- How to Use This Chapter
- Removing the Cover
- Changing the Jumper Settings
- Memory Modules (SIMMs)
- Installing an Option
- Removing an Option Card
- Removing the Option Card Connector Board
- Replacing the Option Card Connector Board
- Installing a New Processor Chip
- Using the Alternate VGA
- Replacing the Cover
- Post-installation Procedures
- CHAP 3-INSTALLING AND REMOVING DRIVES
- CHAP 4-RUNNING SYSTEM DIAGNOSTICS
- CHAP 5-FORMATTING A HARD DISK
- CHAP 6-TROUBLESHOOTING
- APPENDIX A-SPECIFICATIONS
- GLOSSARY
- INDEX
Chapter 3
lnstalling and Removing Drives
The instructions in this chapter describe how to install and
remove optional Epson drives in your computer. You can use
these instructions to install a variety of devices, including
diskette drives, hard disk drives, a CD-ROM drive, or a tape
drive. Although your drive may look different from the ones
illustrated here, you should be able to install it the same way.
If you are installing or removing a non-Epson drive, some of
the steps in this chapter may not apply; see the documentation
that came with your drive for more information.
Installing and Removing Drives
3-1