User`s guide
Table Of Contents
- FRONT MATTER
- CONTENTS
- INTRODUCTION
- CHAP 1-USING YOUR CHAPTER
- Turning On the Computer
- Turning Off the Computer
- Using Disks and Disk Drives
- Special Keys on the Keyboard
- Stopping a Command or Program
- Resetting the Computer
- Using a Password
- Using Your Computer a Network Server
- Changing the Processor Speed
- Preparing the Hard Disk for Moving
- Using AUTOEXEC. BAT and Other Batch Files
- CHAP 2-INSTALLING AND REMOVING OPTIONS
- How to Use This Chapter
- Removing the Cover
- Changing the Jumper Settings
- Memory Modules (SIMMs)
- Installing an Option
- Removing an Option Card
- Removing the Option Card Connector Board
- Replacing the Option Card Connector Board
- Installing a New Processor Chip
- Using the Alternate VGA
- Replacing the Cover
- Post-installation Procedures
- CHAP 3-INSTALLING AND REMOVING DRIVES
- CHAP 4-RUNNING SYSTEM DIAGNOSTICS
- CHAP 5-FORMATTING A HARD DISK
- CHAP 6-TROUBLESHOOTING
- APPENDIX A-SPECIFICATIONS
- GLOSSARY
- INDEX
Removing
SIMMS
If you need to remove SIMMs from your computer (to install
different ones, for example), follow the steps below.
1.
Remove any long option cards that may be blocking your
access to the SIMM sockets. See page 2-18 for instructions.
2.
If you are removing two SIMMs, remove the one from socket
SIMM 2 first. Use your fingers or two small screwdrivers to
pull away the metal tabs that secure the SIMM at each end.
As you pull away the tabs, the SIMM falls to the side.
Carefully remove it from the socket.
3.
If necessary, follow the same procedure to remove the other
SIMM.
Installing and Removing Options
2-13