User`s guide
Table Of Contents
- FRONT MATTER
- CONTENTS
- INTRODUCTION
- CHAP 1-USING YOUR CHAPTER
- Turning On the Computer
- Turning Off the Computer
- Using Disks and Disk Drives
- Special Keys on the Keyboard
- Stopping a Command or Program
- Resetting the Computer
- Using a Password
- Using Your Computer a Network Server
- Changing the Processor Speed
- Preparing the Hard Disk for Moving
- Using AUTOEXEC. BAT and Other Batch Files
- CHAP 2-INSTALLING AND REMOVING OPTIONS
- How to Use This Chapter
- Removing the Cover
- Changing the Jumper Settings
- Memory Modules (SIMMs)
- Installing an Option
- Removing an Option Card
- Removing the Option Card Connector Board
- Replacing the Option Card Connector Board
- Installing a New Processor Chip
- Using the Alternate VGA
- Replacing the Cover
- Post-installation Procedures
- CHAP 3-INSTALLING AND REMOVING DRIVES
- CHAP 4-RUNNING SYSTEM DIAGNOSTICS
- CHAP 5-FORMATTING A HARD DISK
- CHAP 6-TROUBLESHOOTING
- APPENDIX A-SPECIFICATIONS
- GLOSSARY
- INDEX
4.
Push the SIMM into the socket until it is seated firmly in the
slot. Then tilt it upright, as shown below, guiding the holes
at each end of the SIMM over the retaining posts at each
end of the SIMM socket.
If it does not go in smoothly, do not force it; pull it all the way
out and try again.
5.
Repeat steps 3 and 4 for the second SIMM.
6.
Replace any option cards you removed. See page 2-14 for
instructions.
7.
The next time you turn on your computer, run the SETUP
program so your computer can update its configuration
information with the new memory. See Chapter 2 of the
Setup Guide
for instructions.
2-22
Installing and Removing Options