User`s guide
Table Of Contents
- FRONT MATTER
- CONTENTS
- INTRODUCTION
- CHAP 1-USING YOUR CHAPTER
- Turning On the Computer
- Turning Off the Computer
- Using Disks and Disk Drives
- Special Keys on the Keyboard
- Stopping a Command or Program
- Resetting the Computer
- Using a Password
- Using Your Computer a Network Server
- Changing the Processor Speed
- Preparing the Hard Disk for Moving
- Using AUTOEXEC. BAT and Other Batch Files
- CHAP 2-INSTALLING AND REMOVING OPTIONS
- How to Use This Chapter
- Removing the Cover
- Changing the Jumper Settings
- Memory Modules (SIMMs)
- Installing an Option
- Removing an Option Card
- Removing the Option Card Connector Board
- Replacing the Option Card Connector Board
- Installing a New Processor Chip
- Using the Alternate VGA
- Replacing the Cover
- Post-installation Procedures
- CHAP 3-INSTALLING AND REMOVING DRIVES
- CHAP 4-RUNNING SYSTEM DIAGNOSTICS
- CHAP 5-FORMATTING A HARD DISK
- CHAP 6-TROUBLESHOOTING
- APPENDIX A-SPECIFICATIONS
- GLOSSARY
- INDEX
How to Use This Chapter
This chapter explains how to do the following:
Remove the computer’s cover
Change jumper settings on the main system board
Install (and remove) memory modules (SIMMs)
Install an option card
Remove an option card
Remove the option card connector board (to access the
main system board)
Replace the option card connector board
Install a new processor chip (CPU)
Use the alternate VGA interface (feature connector)
Replace the cover.
Follow the steps in the first section to remove the cover, and
then go to the appropriate section for the steps you need. When
you finish, see the instructions at the end of the chapter to
replace the computer’s cover.
2-2 Installing and Removing Options