User`s guide
Table Of Contents
- FRONT MATTER
- CONTENTS
- INTRODUCTION
- CHAP 1-USING YOUR CHAPTER
- Turning On the Computer
- Turning Off the Computer
- Using Disks and Disk Drives
- Special Keys on the Keyboard
- Stopping a Command or Program
- Resetting the Computer
- Using a Password
- Using Your Computer a Network Server
- Changing the Processor Speed
- Preparing the Hard Disk for Moving
- Using AUTOEXEC. BAT and Other Batch Files
- CHAP 2-INSTALLING AND REMOVING OPTIONS
- How to Use This Chapter
- Removing the Cover
- Changing the Jumper Settings
- Memory Modules (SIMMs)
- Installing an Option
- Removing an Option Card
- Removing the Option Card Connector Board
- Replacing the Option Card Connector Board
- Installing a New Processor Chip
- Using the Alternate VGA
- Replacing the Cover
- Post-installation Procedures
- CHAP 3-INSTALLING AND REMOVING DRIVES
- CHAP 4-RUNNING SYSTEM DIAGNOSTICS
- CHAP 5-FORMATTING A HARD DISK
- CHAP 6-TROUBLESHOOTING
- APPENDIX A-SPECIFICATIONS
- GLOSSARY
- INDEX
If you frequently use programs that require low or automatic
speed, use SETUP to change the processor speed. Your new
setting remains in effect until you change it again using SETUP.
See Chapter 2 of the
Setup Guide for
instructions.
If you use these programs only occasionally, you should use
the keyboard commands or the ESPEED program (described
below) to change the processor speed. These methods
temporarily override the SETUP processor speed setting.
Entering Keyboard Commands
You can change the processor speed temporarily by entering a
command from your keyboard. You can use these commands
only if you have enabled the Software speed change option in
the SETUP program.
(Enabled
is the default setting.) If this
option is disabled, you cannot use the keyboard commands.
The keyboard speed setting commands are listed in the table
below.
Speed setting commands
Numeric keypad commands Speed setting
I
/
[Ctrl)[Alt][+l
High
I
Automatic (high speed: low speed
only during diskette access)
(
[Ctrl](Alt](-)
Low (simulated 8
MHz)
To enter these commands, hold down the
m
key and the
m
key simultaneously and then press the
r;-],
m,
or
m
key on the numeric keypad.
1-30
Using
Your
Computer