User`s guide
Table Of Contents
- FRONT MATTER
- CONTENTS
- INTRODUCTION
- CHAP 1-USING YOUR CHAPTER
- Turning On the Computer
- Turning Off the Computer
- Using Disks and Disk Drives
- Special Keys on the Keyboard
- Stopping a Command or Program
- Resetting the Computer
- Using a Password
- Using Your Computer a Network Server
- Changing the Processor Speed
- Preparing the Hard Disk for Moving
- Using AUTOEXEC. BAT and Other Batch Files
- CHAP 2-INSTALLING AND REMOVING OPTIONS
- How to Use This Chapter
- Removing the Cover
- Changing the Jumper Settings
- Memory Modules (SIMMs)
- Installing an Option
- Removing an Option Card
- Removing the Option Card Connector Board
- Replacing the Option Card Connector Board
- Installing a New Processor Chip
- Using the Alternate VGA
- Replacing the Cover
- Post-installation Procedures
- CHAP 3-INSTALLING AND REMOVING DRIVES
- CHAP 4-RUNNING SYSTEM DIAGNOSTICS
- CHAP 5-FORMATTING A HARD DISK
- CHAP 6-TROUBLESHOOTING
- APPENDIX A-SPECIFICATIONS
- GLOSSARY
- INDEX
LI
Do not place diskettes on top of your monitor or near an
external hard disk drive.
Always hold a 5.25-inch diskette by its
protective jacket and never touch the magnetic
surface (exposed by the read/write slot). The
oils on your fingertips can damage it.
Ll
Never wipe, brush, or try to clean diskettes in any way.
Write on a diskette label before you attach it to
the diskette. If you need to write on a label that
is already on the diskette, use only a soft-tip
pen-not a ballpoint pen or a pencil.
D
Carefully label your diskettes and indicate the type and
density. Do not stick several labels on top of one another;
this can make it difficult to insert and remove the diskette
in the drive.
Store diskettes in their protective envelopes and
in a proper location, such as a diskette container.
Do not store diskettes flat or stack them on top
of each other.
Ll
Do not place anything on top of your diskettes, and be sure
they do not get bent.
Using Your Computer 1-11