User`s guide
Table Of Contents
- FRONT MATTER
- CONTENTS
- INTRODUCTION
- CHAP 1-USING YOUR CHAPTER
- Turning On the Computer
- Turning Off the Computer
- Using Disks and Disk Drives
- Special Keys on the Keyboard
- Stopping a Command or Program
- Resetting the Computer
- Using a Password
- Using Your Computer a Network Server
- Changing the Processor Speed
- Preparing the Hard Disk for Moving
- Using AUTOEXEC. BAT and Other Batch Files
- CHAP 2-INSTALLING AND REMOVING OPTIONS
- How to Use This Chapter
- Removing the Cover
- Changing the Jumper Settings
- Memory Modules (SIMMs)
- Installing an Option
- Removing an Option Card
- Removing the Option Card Connector Board
- Replacing the Option Card Connector Board
- Installing a New Processor Chip
- Using the Alternate VGA
- Replacing the Cover
- Post-installation Procedures
- CHAP 3-INSTALLING AND REMOVING DRIVES
- CHAP 4-RUNNING SYSTEM DIAGNOSTICS
- CHAP 5-FORMATTING A HARD DISK
- CHAP 6-TROUBLESHOOTING
- APPENDIX A-SPECIFICATIONS
- GLOSSARY
- INDEX
Mouse Problems
If you have trouble with your mouse or you see an auxiliary
device error message, check the following:
1.
Make sure the mouse cable is securely connected to the
mouse port and not the keyboard port. See Chapter 1 of the
Setup
Guide
for instructions.
2.
If you installed a mouse on an option card, be sure to set
jumper J9 to disable the built-in mouse and set jumper J12
to enable the mouse on the card. See Chapter 2 for
instructions.
3.
Did you install the mouse driver correctly, if necessary? See
your software manual and the documentation that came
with your mouse for instructions. (If you are using
Windows, it has already installed a mouse driver
automatically.)
Memory Module Problems
If you added extra memory to your system by installing SIMMs
and that memory is not operating properly, check the following:
1.
If the memory count displayed by the power-on diagnostics
program is incorrect, you may not have installed the
SIMMs correctly. They may be the wrong type of SIMM or
they may not be inserted all the way.
See “Memory Modules (SIMMs)” in Chapter 2 and make
sure you followed all the instructions.
Troubleshooting 6-23