User`s guide
Table Of Contents
- FRONT MATTER
- CONTENTS
- INTRODUCTION
- CHAP 1-USING YOUR CHAPTER
- Turning On the Computer
- Turning Off the Computer
- Using Disks and Disk Drives
- Special Keys on the Keyboard
- Stopping a Command or Program
- Resetting the Computer
- Using a Password
- Using Your Computer a Network Server
- Changing the Processor Speed
- Preparing the Hard Disk for Moving
- Using AUTOEXEC. BAT and Other Batch Files
- CHAP 2-INSTALLING AND REMOVING OPTIONS
- How to Use This Chapter
- Removing the Cover
- Changing the Jumper Settings
- Memory Modules (SIMMs)
- Installing an Option
- Removing an Option Card
- Removing the Option Card Connector Board
- Replacing the Option Card Connector Board
- Installing a New Processor Chip
- Using the Alternate VGA
- Replacing the Cover
- Post-installation Procedures
- CHAP 3-INSTALLING AND REMOVING DRIVES
- CHAP 4-RUNNING SYSTEM DIAGNOSTICS
- CHAP 5-FORMATTING A HARD DISK
- CHAP 6-TROUBLESHOOTING
- APPENDIX A-SPECIFICATIONS
- GLOSSARY
- INDEX
3.
If you entered an MS-DOS command that you want to stop,
there are special key combinations you can use to cancel the
command. These methods may also work in your
application programs:
Ll
Hold down
(ctll
and press
[cl
Ll
Hold down
m
and press
[Break].
4.
An application program can occasionally lock the computer,
making it unresponsive to keyboard commands. If your
computer does not respond when you type on the
keyboard, you can reset it. Follow the instructions in
Chapter 1.
5.
If resetting the computer does not help, remove any
diskettes, turn off your system, wait 20 seconds, and turn it
back on. Then restart your application program.
If none of these solutions solve your software problem, contact
the software manufacturer for technical support.
Printer Problems
Below are some general steps to follow if you have difficulty
with your printer. If the problem persists and you need more
detailed information, check your printer manual.
You see a port error message if you are having trouble with the
port to which your printer is connected. If your printer uses the
parallel port, you may see error 901; if your printer uses the
serial port, you may see error 1101.
6-20
Troubleshooting