User`s guide
Table Of Contents
- FRONT MATTER
- CONTENTS
- INTRODUCTION
- CHAP 1-USING YOUR CHAPTER
- Turning On the Computer
- Turning Off the Computer
- Using Disks and Disk Drives
- Special Keys on the Keyboard
- Stopping a Command or Program
- Resetting the Computer
- Using a Password
- Using Your Computer a Network Server
- Changing the Processor Speed
- Preparing the Hard Disk for Moving
- Using AUTOEXEC. BAT and Other Batch Files
- CHAP 2-INSTALLING AND REMOVING OPTIONS
- How to Use This Chapter
- Removing the Cover
- Changing the Jumper Settings
- Memory Modules (SIMMs)
- Installing an Option
- Removing an Option Card
- Removing the Option Card Connector Board
- Replacing the Option Card Connector Board
- Installing a New Processor Chip
- Using the Alternate VGA
- Replacing the Cover
- Post-installation Procedures
- CHAP 3-INSTALLING AND REMOVING DRIVES
- CHAP 4-RUNNING SYSTEM DIAGNOSTICS
- CHAP 5-FORMATTING A HARD DISK
- CHAP 6-TROUBLESHOOTING
- APPENDIX A-SPECIFICATIONS
- GLOSSARY
- INDEX
7.
If you see no error messages but there is something wrong
with the data in a file, the operating system or an
application program may have updated the storage
information on the diskette incorrectly. This is probably the
case if you have one of these problems:
Ll
Part of a file is missing
Cl
A file includes parts of other files
CI
An expected output file is missing.
If you are using MS-DOS use CHKDSK to make the necessary
repairs; see your MS-DOS documentation for instructions.
You may also have some special diagnostic software you
can use to check your diskettes.
Diskette Drive
Problems
If you see a diskette error message or have difficulty with a
diskette drive, follow these steps:
1.
If you have problems with a new diskette drive that someone
else installed for you, consult that person about the
problem.
2.
If you installed the drive yourself, did you carefully follow
all the steps in Chapter 3? Review the instructions and
check all the cable connections to make sure you have
installed the drive correctly.
3.
Did you run the SETUP program to automatically configure
the correct type of diskette drive as part of your system?
(See Chapter
2
of the
Setup Guide
for instructions.)
4.
Try running the Diskette drive diagnostic tests described in
Chapter 4. If the diagnostics program indicates an error,
contact your Epson Servicer.
Troubleshooting
6-15