User`s guide
Table Of Contents
- FRONT MATTER
- CONTENTS
- INTRODUCTION
- CHAP 1-USING YOUR CHAPTER
- Turning On the Computer
- Turning Off the Computer
- Using Disks and Disk Drives
- Special Keys on the Keyboard
- Stopping a Command or Program
- Resetting the Computer
- Using a Password
- Using Your Computer a Network Server
- Changing the Processor Speed
- Preparing the Hard Disk for Moving
- Using AUTOEXEC. BAT and Other Batch Files
- CHAP 2-INSTALLING AND REMOVING OPTIONS
- How to Use This Chapter
- Removing the Cover
- Changing the Jumper Settings
- Memory Modules (SIMMs)
- Installing an Option
- Removing an Option Card
- Removing the Option Card Connector Board
- Replacing the Option Card Connector Board
- Installing a New Processor Chip
- Using the Alternate VGA
- Replacing the Cover
- Post-installation Procedures
- CHAP 3-INSTALLING AND REMOVING DRIVES
- CHAP 4-RUNNING SYSTEM DIAGNOSTICS
- CHAP 5-FORMATTING A HARD DISK
- CHAP 6-TROUBLESHOOTING
- APPENDIX A-SPECIFICATIONS
- GLOSSARY
- INDEX
System diagnostic error messages (continued)
Error code
System board
0112
0113
0114
0115
Memory
0201
0201
Diskette drive(s)
0601
0602
0603
0604
0605
0606
0607
Coprocessor
0701
0702
0703
0704
0705
0706
0707
0708
0709
0710
Parallel
port(s)
0901
Serial port(s)
1101
1101
1102
1103
Hard disk drive(s)
1701
1702
1703
Message
CMOS battery error
Interrupt controller error
Protect mode error 1
Protect mode error 2
Memory error
Parity error
Diskette drive controller error
Sequential seek error
Random seek error
Write error
Read error
Remove error
Insert error
Coprocessor not installed
Coprocessor initialize error
Coprocessor invalid operation mask error
Coprocessor st field error
Coprocessor comparison error
Coprocessor zero divide mask error
Coprocessor addition error
Coprocessor subtraction error
Coprocessor multiplication error
Coprocessor precision error
Error pin p
control signal always low
control signal always high
Timeout error
Verify error
Seek error
Write error
Read error
Running System Diagnostics
4-9