User`s guide
Table Of Contents
- FRONT MATTER
- CONTENTS
- INTRODUCTION
- CHAP 1-USING YOUR CHAPTER
- Turning On the Computer
- Turning Off the Computer
- Using Disks and Disk Drives
- Special Keys on the Keyboard
- Stopping a Command or Program
- Resetting the Computer
- Using a Password
- Using Your Computer a Network Server
- Changing the Processor Speed
- Preparing the Hard Disk for Moving
- Using AUTOEXEC. BAT and Other Batch Files
- CHAP 2-INSTALLING AND REMOVING OPTIONS
- How to Use This Chapter
- Removing the Cover
- Changing the Jumper Settings
- Memory Modules (SIMMs)
- Installing an Option
- Removing an Option Card
- Removing the Option Card Connector Board
- Replacing the Option Card Connector Board
- Installing a New Processor Chip
- Using the Alternate VGA
- Replacing the Cover
- Post-installation Procedures
- CHAP 3-INSTALLING AND REMOVING DRIVES
- CHAP 4-RUNNING SYSTEM DIAGNOSTICS
- CHAP 5-FORMATTING A HARD DISK
- CHAP 6-TROUBLESHOOTING
- APPENDIX A-SPECIFICATIONS
- GLOSSARY
- INDEX
Deleting Tests
To remove devices from the Items Detected list so the System
diagnostics program cannot test them, follow these steps:
1.
Press
m
to select
Delete Tests.
You see the Delete
menu, such as the following:
System Board
Numeric Coprocessor
System Memory
Diskette Drive A
Hard Disk Drive #l
Serial Port COMl
Printer Port LPTl
Video Adapter Test
Keyboard Test
2.
Press
m
or
Ir]
to highlight the device you want to
delete and press
m.
The device is removed from the
Delete menu. You can delete as many devices as you want.
3.
When you are finished deleting devices, press
It]
to select
Execute
and see “Running Tests”on page 4-5.
Running System Diagnostics
4-3