User`s guide
Table Of Contents
- FRONT MATTER
- CONTENTS
- INTRODUCTION
- CHAP 1-USING YOUR CHAPTER
- Turning On the Computer
- Turning Off the Computer
- Using Disks and Disk Drives
- Special Keys on the Keyboard
- Stopping a Command or Program
- Resetting the Computer
- Using a Password
- Using Your Computer a Network Server
- Changing the Processor Speed
- Preparing the Hard Disk for Moving
- Using AUTOEXEC. BAT and Other Batch Files
- CHAP 2-INSTALLING AND REMOVING OPTIONS
- How to Use This Chapter
- Removing the Cover
- Changing the Jumper Settings
- Memory Modules (SIMMs)
- Installing an Option
- Removing an Option Card
- Removing the Option Card Connector Board
- Replacing the Option Card Connector Board
- Installing a New Processor Chip
- Using the Alternate VGA
- Replacing the Cover
- Post-installation Procedures
- CHAP 3-INSTALLING AND REMOVING DRIVES
- CHAP 4-RUNNING SYSTEM DIAGNOSTICS
- CHAP 5-FORMATTING A HARD DISK
- CHAP 6-TROUBLESHOOTING
- APPENDIX A-SPECIFICATIONS
- GLOSSARY
- INDEX
Chapter 4
Running System Diagnostics
You can test the following devices using System diagnostics:
D
System board
CI
Numeric coprocessor
tl System memory
Et
Diskette drive(s)
tl
Hard disk drive(s)
Cl
Serial port(s)
il
Parallel port(s)
tl
Video adapter
U
Keyboard
Cl
Dot matrix printer(s).
See the table on page 4-7 for a list of the tests available for each
device.
Note
The Write, read checks for the hard disk drive(s) and
diskette drive(s) destroy data on the disk. Be sure to back up
any data on your hard disk or insert a blank, formatted
diskette before you run this test. Also be sure to do this if
youselect Run all above checks.
Running System Diagnostics
4-1