User`s guide
Table Of Contents
- FRONT MATTER
- CONTENTS
- INTRODUCTION
- CHAP 1-USING YOUR CHAPTER
- Turning On the Computer
- Turning Off the Computer
- Using Disks and Disk Drives
- Special Keys on the Keyboard
- Stopping a Command or Program
- Resetting the Computer
- Using a Password
- Using Your Computer a Network Server
- Changing the Processor Speed
- Preparing the Hard Disk for Moving
- Using AUTOEXEC. BAT and Other Batch Files
- CHAP 2-INSTALLING AND REMOVING OPTIONS
- How to Use This Chapter
- Removing the Cover
- Changing the Jumper Settings
- Memory Modules (SIMMs)
- Installing an Option
- Removing an Option Card
- Removing the Option Card Connector Board
- Replacing the Option Card Connector Board
- Installing a New Processor Chip
- Using the Alternate VGA
- Replacing the Cover
- Post-installation Procedures
- CHAP 3-INSTALLING AND REMOVING DRIVES
- CHAP 4-RUNNING SYSTEM DIAGNOSTICS
- CHAP 5-FORMATTING A HARD DISK
- CHAP 6-TROUBLESHOOTING
- APPENDIX A-SPECIFICATIONS
- GLOSSARY
- INDEX
3.
If you are leaving the drive bay empty, replace the metal
drive bay cover and two retaining screws, as shown below.
4.
If you are replacing the drive you removed with another
drive, remove the guiderails and screws from the drive and
use them to install the other drive as described in
“Installing a Drive in a Horizontal Bay” on page 3-17.
5.
Wrap the drive in its original packing materials and store it
in a safe place.
6.
If you removed your computer’s only hard disk drive,
disconnect the hard disk drive ribbon cable from the system
board and store it as well.
If you removed one hard disk drive and are leaving another
one in the computer, you need to set the jumpers on the
remaining drive to indicate that you now have only one
hard disk drive. See the documentation that came with the
drive for the correct jumper settings.
Installing and Removing Drives
3-31