User`s guide
Table Of Contents
- FRONT MATTER
- CONTENTS
- INTRODUCTION
- CHAP 1-USING YOUR CHAPTER
- Turning On the Computer
- Turning Off the Computer
- Using Disks and Disk Drives
- Special Keys on the Keyboard
- Stopping a Command or Program
- Resetting the Computer
- Using a Password
- Using Your Computer a Network Server
- Changing the Processor Speed
- Preparing the Hard Disk for Moving
- Using AUTOEXEC. BAT and Other Batch Files
- CHAP 2-INSTALLING AND REMOVING OPTIONS
- How to Use This Chapter
- Removing the Cover
- Changing the Jumper Settings
- Memory Modules (SIMMs)
- Installing an Option
- Removing an Option Card
- Removing the Option Card Connector Board
- Replacing the Option Card Connector Board
- Installing a New Processor Chip
- Using the Alternate VGA
- Replacing the Cover
- Post-installation Procedures
- CHAP 3-INSTALLING AND REMOVING DRIVES
- CHAP 4-RUNNING SYSTEM DIAGNOSTICS
- CHAP 5-FORMATTING A HARD DISK
- CHAP 6-TROUBLESHOOTING
- APPENDIX A-SPECIFICATIONS
- GLOSSARY
- INDEX
7.
To insert a hard disk drive, align the guiderails on each side
of the drive with the notches on each side of the drive bay
and slide the drive all the way into the bay, as shown
below. Secure the guiderails to the computer case with the
two retaining screws.
notch
guiderail
Connecting the Cables
To connect the drive to the computer, you need to connect two
cables: a drive ribbon cable and a power supply cable. The
steps below describe how to connect these cables to the drive.
If you are installing a diskette drive, follow step 1 and then skip
to step 3. If you are installing a hard disk drive, start with step 2.
3-24
Installing and Removing
Drives