User`s guide

65
Using the Mail Notification Function to Report Problems
EasyMP Operation Guide
Press the [ ] button on the remote control, move the
cursor to the "OK" button, and then press the [Enter]
button.
The EasyMP standby screen will be displayed again.
If a Problem Notification is Sent by Mail
If an e-mail message with "EPSON Projector" in the subject line is sent to
the IP addressesg that have been set as mail notification destinations, the
message is a notification message saying that there is a problem with the
projector.
The following information will be contained in the body of the message.
Line 1 : The name of the projector where the problem has occurred
Line 2 : The IP address that has been set for the projector where the
problem has occurred
Line 3 : Details of the problem
The details of the problem are listed on separate lines. The following table
shows the details that are given in the message for each item.
*A (+) or (–) will be appended to the start of the message.
(+) : When a projector problem has occurred
(–) : When a projector problem has been solved
5
Message*/Cause Remedy
Internal error
s"Reading the Indicators "in the User’s Guide
Fan related error
Sensor error
Lamp cover is open.
Lamp timer failure
Lamp out
Internal temperature
error
High-speed cooling in
progress
Lamp replacement
notification
No-signal
No image signals are being input to the projector.
Check the connection status or check that the
power for the signal source is turned on.
Downloaded From projector-manual.com Epson Manuals