User`s guide

EasyMP Operation Guide

Using the Mail Notification Function to Report Problems

By setting the mail notification function in the EasyMP network setting,

notification messages will be sent to preset e-mail addresses when a problem

or warning occurs with a projector. This will enable the operator to be notified

of problems with projectors even at locations away from the projectors.

Setting Mail Notification Function

Check the following points before making the mail notification function

settings.

• Network settings have been made to enable the computer and

projector to connect via access point mode or wired LAN connection

mode.

s"Connecting in Access Point Mode or Wired LAN Mode" in the

EasyMP Network Setup Guide

PROCEDURE

Set the projector to EasyMP standby screen.

s"Setting the Projector to Connection Standby Mode" in the

EasyMP Network Setup Guide

Check that the "Config" button in the bottom-right

corner of the screen is selected, and then press the

[Enter] button on the remote control.

Move the cursor to "Network" - "Mail", and then press

the [Enter] button on the remote control.

TIP

•

Up to a maximum of three notification destinations (addresses)

can be recorded, and notification messages can be sent to all three

destinations at once.

•

If a critical problem develops with a projector which causes it to

suddenly stop working, it may not be possible for the projector to

send a message notifying an operator of the problem.

•

If "Standby Mode" in the projector's "Extended" menu is set to

"Network ON", monitoring can be carried out even when the

projector is in standby mode (when the power is off).

Downloaded From projector-manual.com Epson Manuals