User`s guide

36
EasyMP Operation Guide
Sending a Scenario
To project a created scenario using the projector, it is necessary to send the
scenario to the memory card or USB storage device using "Send Scenario" in
EMP SlideMaker2.
Specify the destination between the following two.
• Memory card that is inserted into a card drive of the computer.
• USB hard disk drive or USB memory device that is connected to the
computer's USB port.
It is also possible to set automatic projection and continuous projection of a
scenario at projector startup. The automatic projection function is called
"autorun".
PROCEDURE
Once the scenario has been completed, install a
memory card or USB storage device to the computer
and then select "Scenario Options" - "Send
Scenario".
A window for designating the destination drive is
displayed. Select the drive or port where the memory
card or USB storage device is installed, and then click
the "OK" button.
A confirmation message is displayed. Click the "OK"
button.
The scenario will be sent to the selected drive.
TIP
•
When "Send Scenario" is performed, the scenario file is saved in the
destination under the name "scenario name. sit". In addition, a
folder with the same name as the scenario is created and each screen
is converted to image files and saved according to the image quality
settings.
•
If you use "Send Scenario" without saving, a folder with the same
name as the scenario name and a "scenario name.sit" file are
created in the scenario folder. Each screen is converted to image
files and saved in the created folder according to the image quality
settings.
1
2
3
Downloaded From projector-manual.com Epson Manuals