User`s guide

22
Security Countermeasures for Wireless LAN
EasyMP Operation Guide
Select the encryption method and authentication
method from "WEP", "WPA" or "LEAP".
Move the cursor to the item to be set and then make
the required settings.
Some menu items require characters or numerals to be entered.
See "Entering Characters and Numerals" (sp.24 ) for details on
entering characters and numerals.
WEP
7
8
WEP
g
encryption
This sets the encryption method for WEP encryption.
128bit: 128(104)-bit encryption is used.
64bit: 64(40)-bit encryption is used.
Format
This sets the input method for the WEP encryption key.
HEX: Hexadecimal input
ASCII: Text entry
The method of entering WEP encryption settings with text
varies depending on the access point. Check with the
administrator of the network being used, and try setting to
"ASCII" first.
Key ID
The WEP encryption key ID can be set to either "1", "2", "3"
or "4".
Encryption
key
Enter the encryption key to be used for WEP encryption.
Enter the key using single-byte characters while following the
instructions given by the network administrator for the
network that the projector is connected to. The type and
number of characters to be entered will vary as follows
depending on the "WEP encryption" and "Format" settings.
If the maximum number of characters specified below are not
entered, the portion of data that exceeds the number of
characters entered will not be encoded.
For "128bit" and "HEX":
Up to 26 characters from the range of "0" to "9 and "A" to "F"
For "64bit" and "HEX":
Up to 10 characters from the range of "0" to "9 and "A" to
"F".
For "128bit" and "ASCII ": Up to 13 alphanumeric characters
For "64bit" and "ASCII ": Up to 5 alphanumeric characters
Downloaded From projector-manual.com Epson Manuals