Operation Manual

52
User’s Guide
Functions for Enhancing Projection
This section describes the various useful functions that can be used to enhance
presentations.
Selecting an Image Source While Viewing Projected
Images (Preview Function)
You can momentarily project images from the currently-selected input
source, and switch images while viewing them in a preview screen.
Use the remote control to carry out all preview function operations.
PROCEDURE
Press the [Preview] button on the remote control.
After a short while, a preview screen such as the one shown in
the illustration below will appear on the screen.
When the preview screen is being displayed, the frames for
ports that have no image signal being input or which have a
signal being input that is not supported will be solid blue.
Once you select an input source by pressing any of the Search
buttons on the remote control, the preview function is
terminated and the selected image is projected.
Tilt the [ ] button to select the images to be
projected.
Move the red box until the desired image is selected.
1
Computer (Analog-RGB)
Video
S-Video
ComputerComputer
Easy MP
A
c
ti
ve w
i
n
d
ow
Shows the images that are currently being projected.
Images from the
[S-Video] port
Images from the
[Computer2/
Component] port
Images from the
[Computer1/
Component] port
Images from the [Video]
port
* A blue screen will
appear when no
signals are being input.
If using EMP-835, a
image of EasyMP will
appear
Move the
red box
to the
target
image.
2
Computer (Analog-RGB)
Video
S-Video
ComputerComputer
Easy MP
Move the
red box
to the
target
image.