Operation Manual

41
Turning the Projector OnTurning the Projector On
User’s Guide
PROCEDURE
Press the [Quick Setup] button on either the remote
control or the projector's control panel.
The message "The Quick Setup is in preparation" will be
displayed and the zoom is adjusted to wide automatically.
If projecting onto a screen, whiteboard or blackboard, adjust the
projection area so that it fits within the borders of the screen or
board.
If projecting onto a wall surface without using a projection
screen, blackboard or whiteboard, adjust the projection area to
the desired position and size.
Press the [Quick Setup] button once more.
Adjustment of the projection area will start.
A screen such as that shown below will appear while
adjustment is in progress, but this is normal.
TIP
• You can use the "Quick Setup Options" in the configuration menu
to set which functions are carried out when the [Quick Setup] button
is pressed.
Default setting: Auto Focus and Auto Quick Corner are carried out.
Wall Shot is not carried out.
s"Setting" - "Quick Setup" - "Quick Setup Options" p.81
• "Wall Shot" can also be carried out separately by pressing the [Wall
Shot] button on either the remote control or the projector's control
panel. sp.53
• When Quick Setup is used, the adjusted state will be memorised even
after the projector's power is turned off. If you are using the
projector in a single location all the time, you only need to carry out
Quick Setup once, and from then on you do not need to adjust the
projection area.
• Quick Setup cannot be used when the "Projection" configuration
menu is set to "Rear" or "Rear/Ceiling".
1
Projection area
Borders
2
(While Auto Focus is
being carried out)
(While Auto Quick Corner
is being carried out)