Operation Manual

Turning the Projector OnTurning the Projector On

User’s Guide

PROCEDURE

While pulling the foot adjust lever at the front of the

projector, lift up the front of the projector to extend the

front adjustable foot.

Extend the front adjustable foot until the desired angle is obtained,

and then release the foot adjust lever.

To retract the front adjustable foot, gently push down on the projector

while pulling the foot adjust lever.

If the projector cannot be positioned directly in front of the screen, this

adjustment allows projection to be carried out from the side.

If the projector is set up at an angle of within 25° to the left or right of the

projection area, distortion of the images can be corrected by the horizontal

correction function or the Quick Corner correction.

Foot adjust lever (Front)

TIP

If the projector is tilted vertically or horizontally, turn the bases of the

rear adjustable feet to make fine adjustments to the height of the

projector. If the projector is tilted horizontally, the Auto V-Keystone

correction may not work correctly.

Extend Retract

Rear

adjustable foot

Adjusting the Horizontal Position of the Projection Area

25°

TIP

Press the [Quick Setup] button to start "Auto Quick Corner" to

correct the keystone distortion that occurs as result of projecting

from the side of the screen.

s"One-touch Adjustment of the Projection Area (Quick Setup)"

p.40

sp.70, p.72 Correcting the keystone distortion manually by the H/V-

Keystone and Quick Corner function.