Operation Manual

125
User’s Guide
Saving a User's Logo
You can record the image that is currently being projected as a user's logo.
PROCEDURE
Project the image that you would like to use as a
user's logo, and then press the [Menu] button on
either the remote control or the projector's control
panel.
Select "Extended" - "User's Logo" in the
configuration menu, and then press the [Enter]
button on either the remote control or the projector's
control panel.
Caution
If you use Direct Power Off while a user's logo is being saved, the
user's logo may not be saved correctly. If this happens, repeat the
user's logo saving procedure from the start.
TIP
• When a user's logo is recorded, the previous user's logo will be
erased.
• You cannot save a new user's logo if "User's Logo Protect" in the
Password Protect settings has been set to "ON". Set "User's Logo
Protect" to "OFF" and then save the new user's logo. sp.47
1
2
TIP
If keystone correction or the E-Zoom function have been used, they
will be cancelled when the "User's Logo" menu is selected.