Operation Manual

123

MaintenanceMaintenance

User’s Guide

Install the lamp cover.

Slide the cover to replace it, and tighten the lamp cover fixing

screw on the side of the projector.

Be sure to reset the lamp operating time after replacing the lamp.

The projector has a built-in counter which keeps track of the lamp

operating time, and this counter is use as the basis for displaying the

replacement warning message.

PROCEDURE

Connect the power cable and turn the projector on,

then press the [Menu] button on either the remote

control or the projector's control panel.

The configuration menu will be displayed.

Select "Lamp-Hours Reset" from the "Reset" menu

and then press the [Enter] button on either the remote

control or the projector's control panel.

Resetting the Lamp Operating Time

Caution

• Install the lamp securely. If the lamp cover is removed, the lamp

turns of automatically as a safety precaution. Moreover, the lamp will

not turn on if the lamp or the lamp cover is not installed correctly.

• This product includes a lamp component that contains mercury

(Hg). Please consult your state and local regurations regarding

disposal or recycling. Do not put in the trash.

TIP

Do not reset the lamp operating time except after the lamp has been

replaced. If the lamp operating time is reset at any other time, the

lamp replacement period will not be indicated correctly.

Remote control Projector