Quick Start Guide

The lamp is near the end of its operating life. Replace the lamp with a new one as soon as possible.
If you continue to use the old lamp, the possibility that the lamp may break will increase.
The lamp will switch off automatically
and projection will stop.
Wait for approximately 5 minutes.
After this, check the points to the
right. (With the EMP-8300, disconnect
the power plug first.)
User's Guide "Replacing the Lamp"
If you continue using the projector and
the temperature rises again, the lamp
will switch off automatically.
Check the points to the right.
If the indicator is flashing orange
Warning
Indicator is lit or flashing green or orange
Normal
If you press the button, projection will start after warm-up is complete.
Warm-up time is approximately 40 seconds.
After warm-up is complete, the indicator will change to steady green and projection will start.
Normal operation is in progress.
Cool-down time is approximately 30 seconds.
After cool-down is complete, the projector goes into standby mode.
You cannot use the remote control or the projector's control panel during cool-down.
If the problem is not fixed, stop
using the projector and
disconnect the power plug from
the electrical outlet.
Then contact your dealer or the
nearest address provided in the
"International Warranty
Conditions" section of the
Safety Instructions/World Wide
Warranty Terms booklet.
If the projector
is close to a
wall, move it
away from the
wall.
Clean the air
filters if they are
blocked.
lit flashing off
lit flashing off
Standby
condition
Orange
Cool-down in
progress
Orange
Warm-up in
progress
Green
Projection in
progress
Green
Internal
temperature
error
(overheating)
Red
Red
High-speed
cooling in
progress
Orange
Red
Lamp
replacement
notification
Orange
DVI-D/DVI-D
digital video cable
or DVI-D/DFP
digital video cable
(optional)
VGA-HD15/
BNC PC cable
(optional)
Computer
cable or
VGA-HD15
PC cable
(accessory or optional)
Connecting to a
computer
The [Audio] port to use is
the port that is in the same
box as the port being used
to input the video signals.
* An accessory audio cable
is not supplied with the
EMP-9300. Use a
commercially-available
audio cable instead.
RCA audio cable
(commercially-
available)
To computer's
audio output port
To computer's
audio output port
Audio cable
(accessory)
To computer's monitor
output port
(Mini D-Sub 15-pin)
To computer's monitor
output port
(DVI-D or DFP)
Connections
Be sure to turn the power for all components off before making any
of the following connections.
User's Guide
"Connecting to a Computer"
"Connecting to a Video Source"
9300E-QRG_01-14