User`s guide

84 Presenting Through a Wireless Network

2. Check the access light to make sure it isn’t flashing. Then pull the

module off of the projector.

Connecting to a Wired Network

With the optional Ethernet unit, you can connect the projector to

your network and configure it with an IP address.

1. Remove the wireless module, as described above, then insert the

Ethernet unit into the projector.

2. Connect the projector to your network using a commercially

available 100BaseTX or 10BaseT network cable. Connect the

cable to the

LAN port on the projector.

3. Point the remote control at the projector and press the P

Power

button.

4. Press the

EasyMP button on the remote control to select EasyMP

as the source.

5. Press the

Menu button on the remote control, select the

Network menu, then press Enter.

6. Choose

To Network Configuration and press Enter.

7. Choose

Wired LAN and press Enter.

caution

Never remove the module

while the indicator light is

green or when projecting

wirelessly. You may damage

the module or lose data.

note

Only the Epson Ethernet

unit is guaranteed to work.

Other brands may not be

compatible.

If you see a message asking

you to insert a LAN or

memory card, check to make

sure your Ethernet unit is

roperly inserted.