User`s guide

List of Functions
49
f Wireless LAN Menu
Sub Menu Function
Connection mode Sets the connection mode.
Set "Quick" to establish a quick wireless connection in a 1:1 configuration. Set "Advanced" to connect to the network system via an access point.
Antenna level Displays the wireless LAN wave strength.
Wireless LAN
system
Sets the wireless LAN system.
ESSIDg Enter an ESSID. When an ESSID is provided for the wireless LAN system in which the projector participates, enter the ESSID. The initial value is
EPSON.
You can enter up to 32 single-byte alphanumeric characters.
DHCPg You can set whether to use DHCP (On) or not (Off).
If this is set to "On" you cannot set any more addresses.
IP addressg You can input the IP address assigned to the projector.
You can enter a number from 0 to 255 in each field of the address. However, the following IP addresses cannot be used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)
Subnet maskg You can input the subnet mask for the projector. You can enter a number from 0 to 255 in each field of the address. However, the following subnet
masks cannot be used.
0.0.0.0, 255.255.255.255
Gateway addressg You can input the IP address for the gateway for the projector.
You can enter a number from 0 to 255 in each field of the address. However, the following gateway addresses cannot be used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)