User`s guide

Remote Control of Two or More Projectors
31
C
Press the [Menu] button to close the configuration
menu.
When this setting is completed, only operations from a remote
control having a matching ID or whose ID is set to "0" are
accepted.
Setting the Remote Control ID
You need to set the remote control ID every time you turn on the
projector.
Point the remote control at the remote receiver on the projector you want
to operate.
A
Press the [ID] button.
B
Press the numeric button of the same number as the
ID of the projector you want to operate.
You can operate only the projector with the specified ID number.
Procedure
q
Checking if remote control operation is possible
You can check whether or not remote control operation is
possible on the projector to be operated with the following
procedure.
Press the [ID] button on the remote control pointing at the
remote receiver of the projector to be operated.
When remote control operations are
enabled: