User`s guide

Correcting Distortion in the Projected Image

There are four ways to correct distortion in projected images as below.

Automatic correction

• Quick Setup

Press the [Quick Setup] button to fit on the screen at an aspect ratio

of 4:3.

• Auto V-Keystone

Tilt the projector vertically to automatically correct distortion in the

vertical direction.

Manual correction

• Quick Corner

This allows you to manually correct each of the four corners of the

projected image separately.

• H/V-Keystone

This allows you to manually correct distortion in the horizontal and

vertical directions independently.

The "Quick Setup", "Quick Corner", "Auto V-Keystone" and "H/V-

Keystone" functions project a test pattern onto the screen to correct

the projected image, so connection to a computer for preparing the

projector is not required.

• The default setting in the configuration menu is H/V-

Keystone.

• Select "Settings" - "Keystone" - "Quick Corner" to use

Quick Corner for correction.

• To change the setting from Quick Corner to H/V-Keystone,

press and hold the [Esc] button on the projector or the

remote control for about two seconds and display the

following screen where you can make the change.

Reset Quick Corner: Resets the Quick Corner settings.

Switch to H/V-Keystone: Switches the keystone correction method to

H/V-Keystone. s p.43