Installation guide

INSTALLING THE PROJECTOR IN THE FRAME

Place the frame on the projector so that it is aligned with the screw hole positions. (Make

sure that the forward/back direction is correct when installing. If the direction is reversed

the hole positions will not match.)

Please make sure to use ONLY the

correspondent screw holes when

installing a projector!

Secure the projector in the frame using

the four screws (M6x20) and the eight at

washers (M6).

Do not forget to use the washers as

they are responsible for the galvanic

isolation.

Torque: 5 ± 0.5 Nm

screw (M6x20)

at washers (M6)

max. 2 mm