Service manual

EPSON ELP-3500 Service Manual
3-15
3.2.9 Removing the Receptor Board Assembly
Prerequisite: Complete the steps explained in Section 3.2.1.
Screw
Receptor
Board
Power Supply Unit
Figure 3-18.
1. Remove the screw mounting the receptor to the power supply unit.
Screw: +M3x6 F/Ni: P/N 1033122
Mounting torque: 4.5 kg cm = 3.9 lb inch
2. Disconnect the cable from CN600 on the driver board block, and remove the receptor
board assembly.
Caution:
When installing the receptor board assembly, align the hole in the board with the boss on
the power supply unit before tightening the screw.