Operation Manual

Troubleshooting
97
Check Remedy
Is the power switch on the side of the supplied
WirelessHD Transmitter turned on?
Check the On/Standby indicator on the WirelessHD Transmit-
ter. If there is no power being supplied, make sure the connector
for the AC adapter is securely connected, and then turn on the
power switch.
Is the WirelessHD indicator for the supplied
WirelessHD Transmitter off?
The WirelessHD cannot communicate with the projector. Check
the range within which the WirelessHD's transceiver can com-
municate, and setup within that range.
Is the Link indicator for the supplied Wire-
lessHD Transmitter off?
No signal is output from the AV device connected to the Wire-
less HD T ra nsm itt er . Che ck t ha t the c ab les fro m th e AV dev ic e and
the WirelessHD Transmitter are securely connected.
Are the projector and the WirelessHD Trans-
mitter facing the correct way?
Setup the projector and the WirelessHD Transmitter so that they
are facing each other.
Interference, distortion, or interruption appear in WirelessHD
Check Remedy
Are signals being received within the Wire-
lessHD transmission range?
Check the range within which the WirelessHD's transceiver can
communicate, and view within that range.
s p.57
Are there any obstructions between the Wire-
lessHD Transmitter and the projector?
Because WirelessHD communicates using a tight beamed elec-
tromagnetic wave, if there are any people or objects and so on
obstructing the communication path, this could have an adverse
affect on the image. Make sure that there are no obstacles be-
tween the WirelessHD Transmitter and the projector within the
WirelessHD transmission range.
s p.57
Is the reception too low? If the transmissions are not strong enough, communication may
be unstable.
Check Video Reception as you set up the transmitter as it is
sometimes possible to improve the strength of the transmission
by moving the WirelessHD Transmitter or changing its direc-
tion.s Settings - WirelessHD - Video Reception p.75
Transmission strength may differ depending on the surround-
ings, or they may be unstable. While checking Video Recep-
tion, set up the transmitter at a location where the displayed
value stabilizes.
s Settings - WirelessHD - Video Recep-
tion p.75
Half of the image on the left or right stops projecting or the image is doubled up
Check Remedy
Is the reception too low?
Check Video Reception as you set up the transmitter as it is
sometimes possible to improve the strength of the transmission
by moving the WirelessHD Transmitter or changing its direc-
tion.
s Settings - WirelessHD - Video Reception p.75