Operation Manual

Troubleshooting
96
Check Remedy
Does the connected device meet the HDMI
CEC standards?
If the connected device does not meet the HDMI CEC standards,
it cannot be operated even if it is connected to the HDMI port.
See the documentation and so on supplied with the connected
device for more information.
Also, press the
button, and then check if the device is
available under Device Connections.
s p.62
Are the cables connected correctly? Check that all the cables required to use HDMI Link are securely
connected.
s p.61
Is the power for the amplifier or DVD recorder
and so on turned on?
Put each device in standby status. See the documentation and
so on supplied with the connected device for more information.
If you have connected a speaker and so on, set the connected
equipment to PCM output.
Was a new device connected, or was the con-
nection changed?
If the CEC function for a connected device needs to be set again,
for example when a new device is connected or the connection
is changed, you may need to restart the device.
Are many multi-media players connected? Up to 3 multi-media players that meet the HDMI CEC standards
can be connected at the same time.
The device name is not displayed under Device Connections
Check Remedy
Does the connected device meet the HDMI
CEC standards?
If the connected device does not meet the HDMI CEC standards,
it is not displayed. See the documentation and so on supplied
with the connected device for more information.
Problems with WirelessHD (EH-TW9400W/EH-TW8400W only)
"Transmitter not found." is displayed
Check Remedy
Is the power switch on the side of WirelessHD
Transmitter turned on?
Check the On/Standby indicator on the WirelessHD Transmit-
ter. If there is no power being supplied, make sure the connector
for the AC adapter is securely connected, and then turn on the
power switch.
It may take a while to receive signal.
Cannot project WirelessHD images
Check Remedy
Does the cable connecting the supplied Wire-
lessHD Transmitter meet the HDMI stand-
ards?
If the cable does not meet the HDMI standards, operations are
not possible.
Is WirelessHD set to Off? When WirelessHD is set to Off from the Configuration menu,
projection is not possible for WirelessHD input signals. Set Wire-
lessHD to On and press the
button.s Settings - Wire-
lessHD - WirelessHD p.75
Are signals being received within the Wire-
lessHD transmission range?
Check the range within which the WirelessHD's transceiver can
communicate, and view within that range.
s p.57