Operation Manual

Configuration Menu

Function Menu/Settings Explanation

Subnet Mask

Number from 0 to 255 Enter the projector's subnet mask.

You can enter a number from 0 to 255 in each

field of the address. However, the following sub-

net masks cannot be used.

0.0.0.0, 255.255.255.255

Gateway Address

0 to 255 characters Enter the projector's gateway IP address.

You can enter a number from 0 to 255 in each

field of the address. However, the following gate-

way addresses cannot be used.

0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255

(where x is a number from 0 to 255)

IP Address Display

On, Off Set to Off to prevent the IP address from being

displayed on the Net. Info. - Wired LAN screen.

Others menu

Function Menu/Settings Explanation

PJLink Notification On, Off To use the notification function of PJLink, select

On.

Notified IP Address Number from 0 to 255 Enter the IP address of a computer to be notified

of the projector’s operating status using the

PJLink notification function.

You can enter numbers from 0 to 255. The fol-

lowing IP addresses cannot be used.

127.x.x.x, 224.0.0.0 to 255.255.255.255 (x is a

number from 0 to 255)

AMX Device Dis-

covery

On, Off When you want to allow the projector to be de-

tected by AMX Device Discovery, set this to On.

Set this to Off if you are not connected to an en-

vironment controlled by a controller from AMX

or AMX Device Discovery.

Control4 SDDP

On, Off When you want to allow the projector to be de-

tected by Control4 SDDP, set this to On. Set this

to Off if you are not connected to an environ-

ment controlled by a controller from Control4 or

Control4 SDDP.

Reset menu

Function Explanation

Reset network settings.

You can reset all adjustment values for Network to their default settings.