Operation Manual
Table Of Contents
- Organization of the Guide and Notations in the Guide
- Contents
- Introduction
- Preparing
- Installing
- Connecting a Device
- Preparing the Remote Control
- Basic Operations
- Starting and Ending Projection
- Adjusting the Projected Screen
- Adjusting the Image
- Useful Functions
- Enjoying 3D Images
- Connecting with WirelessHD (EH-TW6600W Only)
- Using the HDMI Link Function
- Playing Back Image Data (Slideshow)
- Projecting Two Different Images Using Picture in Picture
- Configuration Menu
- Troubleshooting
- Maintenance
- Appendix
- Index
Configuration Menu
86
Function Menu/Settings Explanation
IP Settings
(This can only be set
when Connection
Mode is set to Ad‐
vanced.)
DHCP Set whether or not (On/Off) to use DHCP. If specifying the
following address, set it to Off.
IP Address Enter the projector's IP address.
The following IP addresses cannot be used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a
number from 0 to 255)
Subnet Mask Enter the projector's subnet mask.
The following subnet masks cannot be used.
0.0.0.0, 255.255.255.255
Gateway Address Enter the projector's gateway IP address.
The following gateway addresses cannot be used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a
number from 0 to 255)
SSID Display
On, Off Set whether or not (On/Off) to display the SSID onto the LAN
standby screen.
IP Address Display
On, Off Set whether or not (On/Off) to display the IP address onto the
LAN standby screen.
Security menu
Function Menu/Settings Explanation
Security
Off, WPA2-PSK, WPA/
WPA2-PSK
Set a security system.
In Quick, WPA2-PSK is selectable. In Advanced, WPA2-
PSK/WPA/WPA2-PSK is selectable.
Passphrase
- Enter a passphrase.
The passphrase accepts 8 up to 32 single-byte alphanumeric
characters, and is case-sensitive.
In order to ensure security, it is recommended that you
change it periodically.
Reset menu
Function Explanation
Reset network settings.
Resets all adjustment values for Network to their default settings.