Operation Manual
Table Of Contents
- Organization of the Guide and Notations in the Guide
- Contents
- Introduction
- Preparing
- Installing
- Connecting a Device
- Preparing the Remote Control
- Basic Operations
- Starting and Ending Projection
- Adjusting the Projected Screen
- Adjusting the Image
- Useful Functions
- Enjoying 3D Images
- Connecting with WirelessHD (EH-TW6600W Only)
- Using the HDMI Link Function
- Playing Back Image Data (Slideshow)
- Projecting Two Different Images Using Picture in Picture
- Configuration Menu
- Troubleshooting
- Maintenance
- Appendix
- Index
Preparing
18
Connecting a Device
Attention
•
Make cable connections before connecting to a power outlet.
•
When disconnecting, turn off the projector first, then remove the power cord, and then disconnect other
cables.
•
Check the shape of the cable's connector and the shape of the port, and then connect. If you force a connector
of a different shape into the port, it could cause damage and a malfunction to occur.
EH-TW6600W comes with an terminal cover allowing you to clearly see the connector section on the rear.
Remove the terminal cover before connecting any cables.
s
p.22
Connecting Video Equipment
To project images from DVD players or VHS video and so on, connect to the projector using one of the
following methods.
When using an HDMI cable
When using a video cable
When using a component video cable
c
•
The cable differs depending on the output signal from the connected video equipment.
•
Some types of video equipment are capable of outputting different types of signals. Check the user's
guide supplied with the video equipment to confirm which signals can be output.
•
You can also connect your AV system to enjoy the audio from connected equipment.