User Manual
Table Of Contents
- Notations Used in This Guide
- Introduction to Your Projector
- Setting Up the Projector
- Using Basic Projector Features
- Turning On the Projector
- Turning Off the Projector
- Displaying a Test Pattern
- Projection Modes
- Adjusting the Image Position Using Lens Shift
- Adjusting the Projector's Tilt
- Image Shape
- Resizing the Image with the Zoom Feature
- Focusing the Image with the Lens Button
- Selecting an Image Source
- Image Aspect Ratio
- Color Mode
- Adjusting the Image Quality
- Adjusting the Image Color
- Adjusting Projector Features
- Monitoring and Controlling the Projector
- Adjusting the Menu Settings
- Using the Projector's Menus
- Using the Displayed Keyboard
- Image Quality Settings - Image Menu
- Input Signal Settings - Signal I/O Menu
- Projector Installation Settings - Installation Menu
- Projector Display Settings - Display Menu
- Projector Feature Settings - Operation Menu
- Projector Administration Settings - Management Menu
- Projector Network Settings - Network Menu
- Image Quality Memory Settings - Memory Menu
- Projector Initial Settings and Reset Options - Initial/All Settings Menu
- Copying Menu Settings Between Projectors (Batch Setup)
- Maintaining the Projector
- Solving Problems
- Appendix
- Optional Accessories and Replacement Parts
- Screen Size and Projection Distance
- Supported Monitor Display Resolutions
- Projector Specifications
- External Dimensions
- List of Safety Symbols and Instructions
- Laser Safety Information
- Glossary
- Notices
- FCC Compliance Statement
- Indication of the manufacturer and the importer in accordance with requirements of EU directive
- Indication of the manufacturer and the importer in accordance with requirements of United Kingdom directive
- Restriction of Use
- Operating System References
- Trademarks
- Copyright Notice
- Copyright Attribution
Copying Menu Settings Between Projectors (Batch Setup)
90
l
Copy the batch setup file (PJCONFDATA.bin) that you saved to your
computer to the top level folder of the removable disk.
a
Do not copy any files or folders other than the batch setup file to
the removable disk.
m
Eject the USB device (Windows) or drag the removable disk icon to the
Trash (Mac).
n
Disconnect the USB cable.
When all of the indicators start flashing, the settings are being written.
When writing is finished, the projector turns off.
Caution
Do not disconnect the power cord from the projector while the file is being
written. If the power cord is disconnected, the projector may not start
correctly.
gg Related Links
• "Batch Setup Error Notification" p.90
Batch Setup Error Notification
The projector's indicators notify you if an error occurs during a batch setup
operation. Check the status of the projector's indicators and follow the
instructions described in the table here.
Indicator status Problem and solutions
• Laser: Orange - flashing
fast
• Temp: Orange - flashing
fast
The batch setup file may be corrupt, or the USB flash
drive may not be connected correctly.
Disconnect the USB flash drive, unplug and then plug
in the projector's power cord, and then try again.
Indicator status Problem and solutions
• Power: Blue - flashing
fast
• Status: Blue - flashing
fast
• Laser: Orange - flashing
fast
• Temp: Orange - flashing
fast
Writing the settings may have failed and an error may
have occurred in the projector's firmware.
Stop using the projector, remove the power plug from
the electrical outlet. Contact Epson for help.