User Manual

Projector Network Settings - Network Menu
85
Setting Options Description
IP Settings DHCP
IP Address
Subnet Mask
Gateway Address
Set DHCP to On if your network assigns
addresses automatically; set to Off to
manually enter the network's IP
Address, Subnet Mask, and Gateway
Address using 0 to 255 for each address
field.
Do not use these addresses: 0.0.0.0,
127.x.x.x, 192.0.2.x or 224.0.0.0 through
255.255.255.255 (where x is a number
from 0 to 255) for IP Address,
255.255.255.255 or 0.0.0.0 through
254.255.255.255 for Subnet Mask, and
0.0.0.0, 127.x.x.x or 224.0.0.0 through
255.255.255.255 for Gateway Address.
IP Address Display On
Off
Set to On to display the IP address on the
network information screen.
Network Menu - Projector Control Menu
Settings on the Projector Control menu let you select settings for controlling
the projector over a network.
Setting Options Description
PJLink On
Off
Set to On to enable the PJLink
notification function.
PJLink Password Up to 32
alphanumeric
characters
(do not use spaces
and any symbols
other than @)
Enter a password for using the PJLink
protocol for projector control.
Setting Options Description
Notified IP Address Various IP
addresses
Enter the IP address to receive the
projector's operating status when the
PJLink notification function is enabled.
Enter the addresses using 0 to 255 for
each address field.
Do not use these addresses: 127.x.x.x or
224.0.0.0 through 255.255.255.255
(where x is a number from 0 to 255).
AMX Device
Discovery
On
Off
Set to On when you want to allow the
projector to be detected by AMX Device
Discovery.
Control4 SDDP On
Off
Set to On to allow device information to
be acquired using Control4 Simple
Device Discovery Protocol (SDDP).